HUMIDITY & TEMPERATURE CONTROLLERS
MODEL : PE 9100
Premier’s Model PE 9100 is a controller for humidity and temperature and also a logger. It has three output for SRR interface to efficiently control the Humidity and Temperature. PE 9100 is an ON/OFF Controller with logic for compressor ON/OFF (with programmable Time delay) and Heater ON/OFF for temperature control and stem ON/OFF for Humidity Control.
PE 9100 has RS232 output for computer or Printer interface and also has the built in Real Time Clock along with non-volatile memory . It prints data at every Print Interval in On-Line Mode. In Off – Line Mode it stores all the datain its memory which can be printed on the Dot Matrix Printer thro Serial Port or can be taken on Computer.
On/Off with hysterisis or Proportional Control.
Controls both RH and Temperature.
Two 5 Amp relay contacts.
Panel mounting size.
Adjustable dead bands for Relative Humidity and temperature.
Low Relative Humidity measurement – optional.
RS 232 / RS 422 output for PC interface.
Real Time Clock with calendar for Datalogging.
3 ½ digit,LED , 0.5” ht red LED.
RTD Pt – 100 type sensor for temperature.
Humidity Sensor with 0 – 3 V DC output.
10 to 90% RH for humidity ( temperature compensated )
-90 to 90 ° C for temperature ( Pt – 100 , RTD type sensor ).
1 % RH , 0.1 / 1 °C.
1% +/- 1RH , 0.5% +/- 1 count.
Response Time :
Less then 30 sec.
Two nos – Digitally adjustable from 0 to 100 % RH, 0 to 85 °C.
Adjustable from 0 to 50% RH , 0 to 50 °C.
Dual , 1 C/O , 5A/230 VAC.
230 V AC +/- 10% , 50 Hz.
96(w) X 96(h) X 130(d) mm.
Panel Mounting Type – Panel Cutout 92 (w) x 92 (h) mm.